Mending loom for a woven darn

A small mending loom holds parallel warp threads above a hole. Tilting its hooks opens alternate paths for a needle, so you can weave a little rectangle directly onto the garment.

Weave across the hole

  1. Place the disk under the damaged spot. Secure the cloth and hook bar with the supplied band. Smooth the fabric to its normal shape.

  2. Anchor the yarn in sound cloth below the hole. Take it up around a hook and return to the lower edge. Continue across enough hooks to cover the whole weak area.

  3. Tilt the hooks together. Slide the needle through the opening under the raised warp threads and catch sound fabric beside the darn.

  4. Tilt in the opposite direction and weave back. Set each row against the last without pulling the edges inward.

  5. Work into sound fabric beyond the hole. Lift the loops off the hooks and tack each one down. Weave the tails through the darn and check it off the disk.

Parts of a hook loom

PartJob
Disk and bandHold one layer of the garment smooth under the opening.
Hook barSeparates alternate warp threads for each pass.
Long needleCarries the crosswise weft through the opening and into sound cloth.

Questions

Can a loom darn stretch like ribbing?
A woven rectangle stretches less than a knit. Keep it small and place it where that loss of stretch will be comfortable.
Why is the patch narrower at the top?
The weft may be pulled too tight at the turns. Leave a small arc before settling each pass against the row below.

Related guides